MRAT Compensator for FN Reflex Pistol

Description

The MRAT Compensator for the FN Reflex pistol is a direct thread-on solution built for the harsh realities of an Arizona desert shooter. Designed to handle high dust, extreme heat, and suppressor-friendly setups, this compensator delivers real, measurable performance without the hassle of permanent installation.

Performance You Can Feel
The MRAT reduces muzzle rise by 30-40% (depending on ammunition) and cuts felt recoil significantly. Its unique angled ports redirect gases upward, keeping the muzzle down between shots. This means faster sight reacquisition during follow-up shots, less fatigue during long range sessions, and a noticeable reduction in “trigger pinch” after each round. More control, less snappiness—just more fun on the range.

Designed for Real-World Conditions
This compensator was tested extensively with SAAMI spec ammunition—from light target loads to +P duty rounds. It handles the heat and dust of the desert without issue. Note: hand loads with less than SAAMI spec pressure may induce malfunctions, so stick with factory or properly loaded ammunition.

Mounting That Works When You Need It
The MRAT uses a built-in clamp, Wire EDM cut directly into the compensator profile. No thread locker needed—just torque the clamping screws to 25 in-lb. This allows fast, secure mounting and removal from the barrel. You can clean the comp or swap to a suppressor without fighting with thread locker compounds. The two clamping screws sit on opposite sides of the barrel threads, ensuring equal clamping force and preventing misalignment. This is the result of nearly two years of testing to give you a compensator that stays put when you need it and comes off when you don’t.

Clean, Streamlined Fit
Wings on the compensator body cover the gap between the slide and comp, giving the pistol a finished, integrated look. No sharp edges or exposed threads—just a clean profile that matches the FN Reflex’s lines.

Specs & Fitment

• Price: $140
• Category: FN, FN Reflex
• Mounting: Direct thread-on with built-in clamp (Wire EDM cut)
• Torque Spec: 25 in-lb on clamping screws – do not use thread locker
• Muzzle Rise Reduction: 30-40% (ammo dependent)
• Compatible Ammo: SAAMI spec target to +P duty rounds
• Removal: Easy off for cleaning or suppressor use
• <