Curved Forward Set Sear & Trigger Kit for M&P

Description

This Curved Forward Set Sear & Trigger Kit for the M&P is built specifically for shooters who operate in demanding conditions like the Arizona desert—where dust, heat, and suppressor use are part of the daily routine. Priced at $180, this kit upgrades your factory trigger to deliver a pull that closely mimics the crisp, short action of a single-action 1911, but in a reliable polymer duty pistol. It’s engineered to handle high-round counts, blowing dust, and the added back pressure from a suppressor without compromising performance.

Real benefits for your shooting experience:

• Reduced trigger pull weight to approximately 4 to 5 lbs. This makes it easier to manage follow-up shots and maintain accuracy, especially when your hands are hot, sweaty, or covered in desert grit.
• Overall trigger travel reduced by about 40%. Less finger movement means faster, more consistent shots—critical when you’re shooting from awkward positions or with a suppressor adding weight to the front of the gun.
• Shorter pre-travel, over-travel, and reset distance. You get a quicker recovery between shots, which directly translates to tighter groups on steel or paper in high-heat conditions.
• Smoother uptake and reset. The trigger moves cleanly without the gritty feel that factory triggers can develop when dust and carbon build up. This keeps your pull consistent round after round.
• Crisp trigger break. No mush, no creep—just a clean wall that breaks predictably. This is especially valuable when shooting suppressed, where the extra gas and noise can throw off your timing.
• Maintains factory safety values. The center-mounted pivoting safety keeps all original drop-safety and trigger-block features intact. You get a better trigger without sacrificing reliability or safety in a duty or carry gun.
• Direct drop-in installation. No fitting, no filing, no gunsmith required. You can install this kit at your workbench with basic tools and be back on the range in minutes.

Specs and fitment naturally integrated: This kit uses a combination of Apex springs and the factory sear and trigger return springs, allowing you to adjust pull weight between 4 and 5 lbs. depending on your preference—lighter for competition, heavier for duty or carry. It is a drop-in replacement for all M&P models (full-size, compact, and Shield variants) that use the standard M&P trigger system. The curved forward set design places your finger in a consistent position for a more natural pull, reducing the tendency to push or pull shots off target